Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
13
ODSHR Series
20002264
7. Finish Wall
Finish the wall with material of your choice. Do not
install a combustible mantel shelf less than 12
inches above the front opening. If a combustible
material is used below a flat mantel shelf, consult your
local building codes for minimum clearance from top of
fireplace opening to bottom of mantel shelf.
All joints (top, bottom and sides) where wall or decora-
tive facing material meets fireplace surround must be
completely sealed with a noncombustible material.
(Figs. 18, 19, 20)
Note: No side wall protection is required for fireplaces
installed at 45 degrees to two (2) side walls (corner
installation).
FP559SHR
Fig. 17 Minimum clearances to combustibles.
Air Space Clearances
Combustible framing material MUST NOT
penetrate AIR SPACE (shaded areas)
Standoff
2"
³⁄₄" Air Space
to Sides
Firestop
Front View
Side View
Wall
Shield
³⁄₄" Air Space
to Back
³⁄₄" Air Space
to Sides
0" Clearance to
Floor
Hearth Extension
Only noncombustible
material may be applied as
facing to the fireplace
surround.
Flat Mantel Shelf
12" Min. to Top of
Fireplace Opening
Stud
2 x 4 Finished
Header
Ledge Bracket
Finished Wall
Must be Sealed with
Noncombustible Material
Surround
Finished Wall
2 x 4 Stud
1"
Ledge Bracket
Finished
Wall
Must be Sealed
with Noncombus-
tible Material
F P531
Fig. 18 Fireplace surround flush with finished wall.
Finished Wall
Stud
Noncombustible
Decorative
Facing
Must be Sealed with
Noncombustible
Material
Surround
2 x 4 Header
Ledge Bracket
FP1166
Fig. 19 Fireplace surround flush with finished wall.
Side View