KitchenAid KFRU271VSS Gas Grill User Manual


 
14
Do not let the cord hang over the edge of a table or touch
hot surfaces.
Do not use an outdoor cooking appliance for purposes
other than intended.
When connecting, first connect plug to the outdoor
cooking gas appliance then plug appliance into the outlet.
Use only a Ground Fault Interrupter (GFI) protected circuit
with this outdoor cooking gas appliance.
Do not remove the ground prong or use with an adapter
of 2 prongs.
Use only extension cords with a 3 prong grounding plug
rated for the power of the equipment and approved for
outdoor use with a W-A marking.
NOTE: Check the circuit breaker on the back of the grill after
plugging the grill into a 3-prong polarized type outdoor GFI
outlet if there is a loss of electrical power to the grill. Reset
the circuit breaker if the button is in the tripped position. Push
in the rubber boot and button to reset.
3. Go to “Check and Adjust the Burners” section
GAS CONVERSIONS
NOTE: These instructions are for grill models that come equipped with the conversion kit for Local LP and Natural gas. For models that
do not come equipped with the conversion kit: for conversion to Local LP order Regulator Part Number W10132702, or for conversion
to Natural gas order LP to Natural Gas Conversion Kit Part Number W10118098. Use the conversion instructions included in the kit.
See “Assistance or Service” section for information on ordering.
Tools and Parts for Gas Conversion
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools needed
Parts supplied
Brass connector
Convertible regulator 4" W.C. Natural, 11" W.C. LP
Natural gas orifices
IMPORTANT: Gas conversions must be done by a qualified
installer. Before proceeding with conversion, shut off the gas
supply to the appliance prior to disconnecting the electrical
power.
This kit is designed for use from sea level up to 2000 ft elevation.
For higher elevations contact KitchenAid at 1-800-422-1230 in
the U.S.A. or call 1-800-607-6777 in Canada.
A. Rubber boot
B. Circuit breaker button in
“set” position
A. Rubber boot
B. Circuit breaker button
in “tripped” position
A
B
A
B
Phillips screwdriver
Pipe wrench
Adjustable wrench
10 mm wrench
6 mm socket and wrench
or 6 mm nut driver
10 mm socket and wrench
or 10 mm nut driver
Thin flat-blade screwdriver
Pliers
Pipe thread sealant
certified for LP gas
WARNING
Explosion Hazard
Use a new CSA International approved “outdoor”
gas supply line.
Securely tighten all gas connections.
If connected to LP, have a qualified person make sure
gas pressure does not exceed 11” (28 cm) water
column.
Examples of a qualified person include:
licensed heating personnel,
authorized gas company personnel, and
authorized service personnel.
Failure to do so can result in death, explosion, or fire.