Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
21
Manually lighting the side burner
1. Remove the outdoor side burner cover.
2. Remove the manual lighting extension (see following
illustration) and attach a match to the split ring.
3. Strike the match to light it.
4. Guide the match to the burner you wish to light.
5. Do not lean over the side burner. Push in and turn the burner
knob to LITE/HI for the burner closest to the lit match. The
burner will light immediately. When burner is lit, turn knob to
desired setting.
6. Repeat for each of the other burners as needed.
7. Remove match and replace manual lighting extension inside
its holder.
IMPORTANT:
If burner does not light immediately, turn the burner knob to OFF
and wait 5 minutes before relighting.
If any burners do not light after attempting to manually light them,
contact the KitchenAid Customer eXperience Center. See the
“Assistance or Service” section.
OUTDOOR SIDE BURNER CARE
General Cleaning
IMPORTANT: Before cleaning, make sure all controls are off and
the side burner is cool. Always follow label instructions on
cleaning products.
For routine cleaning, wash with soap and water using a soft cloth
or sponge. Rinse with clean water and dry at once with a soft,
lint-free cloth to avoid spots and streaks.
Do not use steel wool to clean the side burner, as it will scratch
the surface.
To avoid weather damage to finish, use stainless steel side
burner cover.
STAINLESS STEEL
IMPORTANT: To avoid damage to stainless steel surfaces, do not
use soap-filled scouring pads, abrasive cleaners, Cooktop
Polishing Creme, steel wool, gritty wash cloths or paper towels.
To avoid damage to the finish, cleaners should not contain
chlorine.
Food spills should be cleaned as soon as entire side burner is
cool. Spills may cause permanent discoloration.
Cleaning Method:
■ Rub in direction of grain to avoid scratching or damaging the
surface.
■ KitchenAid
®
Stainless Steel Cleaner and Polish Part Number
4396920 (not included) or KitchenAid
®
Stainless Steel Wipes
Part Number 8212510 (not included):
See “Assistance or Service” section to order.
■ Liquid detergent or all-purpose cleaner:
■ Rinse with clean water and dry with soft, lint-free cloth.
■ Vinegar to remove hard water spots.
■ Glass cleaner to remove fingerprints.
EXTERIOR
The quality of this material resists most stains and pitting,
providing that the surface is kept clean, polished and covered.
■ Apply stainless steel polish to all non-cooking areas before
first use. Reapply after each cleaning to avoid permanent
damage to surface.
■ Cleaning should always be followed by rinsing with clean
warm water.
■ Wipe the surface completely dry with a soft cloth.
■ For tough spots or baked-on grease, use Kitchen and BBQ
Grill Degreaser Part Number 31617, a commercial degreaser
designed for stainless steel.
See “Assistance or Service” section to order.
INTERIOR
Discoloration of stainless steel on these parts is to be expected,
due to intense heat from the burners. Always rub in the direction
of the grain. Cleaning should always be followed by rinsing with
clean, warm water.
Cleaning Method:
■ Liquid detergent or all-purpose cleaner.
■ Rinse with clean water and dry completely with a soft, lint-
free cloth.
■ A heavy-duty scrub sponge can be used with mild cleaning
products.
■ For small, difficult-to-clean areas, use Kitchen and BBQ Grill
Degreaser Part Number 31617, a commercial degreaser
designed for stainless steel.
See “Assistance or Service” section to order.