Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Grill Lighting Instructions
1. Before each use, check all hoses for cracks, nicks,
cuts, burns or abrasions. If a hose is damaged in any
way, do not use your grill before replacing the hose
with an authorized part from the Parts List. Also make
sure all gas supply connections are securely tight-
ened.
2. Familiarize yourself with the safety and Use and Care
instructions in this manual. Do not smoke while
lighting grill or checking gas supply connections.
3. Be sure the LP Gas tank is filled.
4. Open the Grill Lid.
5. Check that the end of each Burner Tube is properly
located over each Valve Orifice.
Failure to replace a faulty hose, secure gas supply
connections or to open the Lid before proceeding
to the Lighting Procedures could result in a fire or
explosion that could cause serious bodily injury,
death, or property damage.
6. Set Control Knobs to OFF and open the LP Gas tank
valve SLOWLY 1/4 of a turn.
I
OFF
Open LP Gas_
_-
7. Push and turn the Left Control Knob to HIGH.
HIGH MED
OFF _ LOW
8. Immediately press the Electric Ignitor for 3-4
seconds to light the Burner.
If ignition does not occur in 5 seconds, turn the
burner Control Knob(s) and gas source OFF and
conduct a leak test of ALL gas connections and
gas sources as explained in the Use and Care
section of this manual. If no leaks are detected,
wait 5 minutes for any gas to clear and repeat
the lighting procedure.
Side Burner Lighting Instructions
1. Follow steps 1 through 3 of the Grill Lighting
Instructions.
2. Open Side Burner Lid.
3. Set Control Knob to OFF and open the LP Gas tank
valve 1/4 ~ 1/2 turn SLOWLY.
Push and turn the Control Knob on Side Burner to
HIGH.
Press the Electric ignitor for 3-4 seconds to light the
Burner.
5. If the burner does not light, turn the knob to OFF.
Wait 5 minutes, then retry or light by using lighting
stick with a match.
If ignition does not occur, turn the burner Control
Knob and gas source OFF and conduct a leak test of
ALL gas connections and fuel sources. If no leaks
are detected, wait 5 minutes for any gas to clear and
repeat the lighting procedure.
Manually Lighting Your Grill By Paper Match
To light your gas grill by match, insert a match into the
Lighting Stick and follow steps 1 through 6 of the Grill
Lighting Instructions. Then, light the match and place
Lighting Stick through the Lighting Hole on the left side
of the grill as shown below. Turn the nearest Control
Knob to the HIGH setting to release gas. The Burner
should light immediately.
LIGHTING I
HOLE
LIGHTING /_
STICK
\
MATCH
PRESS
9. After the Burner is lit, turn the tank valve SLOWLY
one more 1/4 of a turn for 1/2 of one complete turn.
Never lean over the grill cooking area while
lighting your gas grill. Keep your face and body
a safe distance (at least 18 inches) from the
Lighting Hole or Burners when lighting your grill
by match.
Once Left Burner is lit, the right adjacent Burner(s)
can be lit by turning its Control Knob to HIGH in
sequence from left to right.
2O