Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Install Ignitor Battery
[] Unscrew the ignitor Cap from Control Panel.
[] Place supplied AA battery into the Ignitor
Slot with positive pole facing you.
[] Position the Cap and Spring over the AA
battery and tighten onto Control Panel.
Main Burners Electrode Check
Perform this Electrode Check with the
assistance of another person.
This test will ensure that the Spark Electrode Tips
are properly positioned so your grill lights easily
and properly.
Spark Gap Gas Collector Box Inside Nut
AA BATTERY
IGNITOR CAP_ j_
---.<.
SPRING
IGNITOR
SLOT
Spark Receiver Spark Electrode Tip
[] Be sure all Control Knobs are set to
"OFF" and open the Grill Lid.
[] Have your assistant stand behind and to
the right of the grill facing toward the
front of the grill bowl. Never put your
face inside the Grill Bowl.
[] Press the Ignitor Cap. You should hear
a "clicking" sound. Your assistant should
see a blue spark within Left Gas
Collector Box. if a spark is present the
Electrode Tips are properly positioned.
[] if no spark is seen, the Spark Gap
needs to be adjusted as follows:
• Using an adjustable wrench, loosen the
inside Nut until the Gas Collector Box can
be turned upward.
• if the gap between the Spark
Electrode Tip and Receiver is more
than 3/16" use long nose pliers to
gently squeeze the Gas Collector Box
to narrow the gap.
• Return the Gas Collector Box to its
original position, secure the inside Nut
and try the Electrode Check again, if no
"clicking" sound is heard:
- AA Battery may be installed back-
- wards. Electric wires may be loose.
Remove the AA Battery and inspect
the ignitor Junction Box found behind
the Control Panel and reconnect any
loose wires.
Side Burner Electrode Check
[] Open the Side Burner Lid and remove the
plastic shipping band from the burner and
the pot support.
[] Be sure Control Knob is set to "OFF" and
open the Side Burner Lid. Press the Ignitor
Cap. You should hear a "clicking" sound
and see a blue spark between the tip of the
electrode and burner.
[] If you don't see a spark from the side burner
electrode, adjust gap between electrode and
burner surface to 3/16 inches.
Install Cooking Components
[] Place the Savor Plates ® (holes face rear
of bowl) on lower ledge above Burners.
[] Place Cooking Grids on bowl ledge.
[] Place the Secondary Cooking Rack into
the slots on Grill Bowl Side Panels.
SECONDARY
COOKING RACK
Model 141.16322
SLOTS FOR SECONDARY
COOKING RACK
Model 141.16324
When you have finished assembling your
grill be sure that all screws are tightened
for safe operation of your grill.
16
Failure to read and follow the Use and Care
Instructions could result in a fire or explosion
that could cause serious bodilyinjury, death or
property damage.