Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Z WARNING
If you smell gas:
• Shut off gas supply to the gas grill.
• Turn the Control Knobs to OFF position.
• Extinguish any open flame such as candle,
cigarette, lighter, etc., that could cause gas
to ignite.
• Open the Grill Lid.
• Get away from the LP gas tank.
• Do not try to fix the problem yourself.
• If odor continues or you have a fire you
cannot extinguish, call your fire
department. Do not catl near the LP gas
tank because your telephone is an electri-
cal device and could create a spark
resulting in fire and/or explosion.
NOTE: The normal flow of gas through the
regulator and hose assembly can create a
humming noise. A low volume of noise is
perfectly normal and will not interfere with
operation of the grill. If humming noise is
loud and excessive you may need to purge
air from the gas line or reset the regulator
excess gas flow device. This purging proce-
dure should be done every time a new LP
gas tank is connected to your grill. For hetp
calt the Grill Information Center.
Basic Lighting Procedures
1. Famitiadzeyourselfwiththesafetyguidetinesat
thefront of this manual. Do not smoke while
lighting grill or checking gas supply connections.
2. Be sure the LP gas tank is filled.
3. Check that the end of each Burner Tube is properly
located over each Valve Orifice.
4.
5.
Make sure alt gas connections are securely
tightened.
Open the Grill Lid or Side Burner during lighting,
depending on the burner you are lighting.
WARNING
Failure to open Grill Lid during the
lighting procedures could result in a fire
or explosion that could cause serious
bodily injury, death, or property damage.
.
Set Control Knobs to OFF and open the LP gas
tank valve slowly until 1/4 to 1/2 open.
Open LP
gas tank
l -"--
OFF
Never test for leaks with a flame. Prior to first
use, at the beginning of each season, or every
time your LP gas tank is changed, you must
check for gas leaks. Follow these four steps:
1. Make a soap solution by mixing one part
liquid detergent and one part water.
2. Turn the grill Control Knobs to the full OFF
position, then turn the gas ON at source.
3. Apply the soap solution to all gas
connections. If bubbles appear in the soap
solution the connections are not properly
sealed. Check each fitting and tighten or
repair as necessary.
4. If you have a gas leak that cannot be
repaired by tightening, turn off the gas at the
source, disconnect fuel line from your grill and
call 1-800-4-MY-HOME (_ or your gas supplier
for repair assistance.
_J
7. Push and turn the LEFT Control Knob to HIGH.
l
HIGH
OFF
8. Immediately press the Electric Ignitor for 3-4
seconds to light the Burner.
PRESS
9. If ignition does not occur in 5 seconds, turn the
burner control(s) off, wait 5 minutes, and repeat the
lighting procedure.
10. Once the left grill burner is ignited, the adjacent
burner can be lit by simply turning its Control Knob
to HIGH.
11. Adjust Control Knobs to your desired cooking
temperature.
17