Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
_'_ Installing Cooking Components
Important: Before cooking on your grill the first
time, wash the Cooking Grids with warm, soapy
water. Rinse and dry thoroughly. Season with
cooking oil regularly. After cooking is completed,
turn grill to HIGH setting for about five minutes to
bum off excess grease or food residue.
1. Place the 3 Steel Flame Tamers on the lower
ledge above Burners.
2. Evenly space the Cooking Grids on the ledge
above the Flame Tamers.
3. Place the Secondary Cooking Rack into the
slots on the upper left and upper right of Grill
Bowl Side Panels.
SECONDARY
COOKING
TAMER
SLOT_
RACK
Connecting A Liquid Propane Gas
(LPgas) Tank To Your Grill
1. Place a 20 Ib tank with foot ring into the
hole in the Bottom Shelf. Seel_ _ Make
sure the tank valve is in the OFF positon.
(Turn clockwise to close.) Use provided Wing
Bolt to secure gas tank.
Wing Bolt 1/4"x4-3/8"
Qty, 1
Ref, # $233G04382
2. Check the tank valve to insure it has proper
external mating threads to fit the hose &
regulator assembly provided. (Type 1 connec-
tion per ANSI Z21.58b-2002)
3. Be sure all Burner Valves are in the OFF
position.
I
4. Inspect the valve connection port and regulator
assembly. Look for damage or debris. Remove
any debris. Inspect hose for damage. Never
use damaged or plugged equipment.
5. When connecting the regulator assembly to
the tank valve, hand tighten nut clockwise to
a full stop. SeelFJ_F_11DONOT use a wrench
to tighten because it could damage the Quick
Coupling Nut and result in a hazardous
condition.
6. Open the tank valve fully (counterclockwise).
Use a soapy water solution to check all
connections for leaks before attempting to light
your grill. See "Checking for LP Gas Leaks"
on page 17. If a leak is found, turn the tank
valve off and do not use your grill until the
leak is repaired.
1,
2,
Disconnecting A Liquid Propane Gas
(LP gas) Tank From Your Grill
Turn the Burner Valves and LP gas tank valve
to the full OFF position. (Turn clockwise to
close.)
Detach the hose and regulator assembly from
the LP gas tank valve by turning the Quick
Coupling Nut counterclockwise.
Type I connection
per ANSi Z21.58b-2002
16
QUICK
COUPLING
NUT
CAUTION: When the appliance is not in use, the
gas must be turned off at the supply tank.
Congratulations
Your Kenmore LP gas grill is now ready for
use. Before the first use and at the beginning
of each season (and whenever the LP gas
tank has been changed):
1. Read all safety, lighting and operating
instructions.
2. Check Gas Valve Orifices, Burner Tubes
and Burner Ports for any obstructions.
3. Perform gas leak check according to
instructions found on page 17 of this
manual.