Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Install Side Burner Control Panel to Side Burner Assembly
[] Attach Side Burner Control Panel (iv]) to Side Burner Assembly using 3 Phillips Head
Bolts and 2 Washers. Do not use a Washer on the end Bolt.
No Washer
Phillips Head Bolt: M4x5/16"
(Black)
Qty: 3
Part # SB0009
Washer: M4
Qty: 2
Part # SB0016
With Washer
Install Side Burner Assembly to Firebox Assembly,
[] Loosely screw 2 Phillips Head Bolts (M6x3/8") and 2 Washers into the upper left and
right corner holes in the left side of the firebox as shown in Inset 1. Leave 1/4" of the
bolts extending out of the firebox sides to attach the side burner brackets. Slide the Side
Burner Front and Rear Brackets over the heads of those bolts and tighten.
[] Slide the side burner ignition wire through the hole on the Side Burner Control Panel.
See Inset 2
[] Use 2 Phillips Head Bolts (M6x3/8") and 2 Washers to attach the lower holes in the Side
Burner Front and Rear Bracket to the Firebox Assembly (t) as shown in Inset 3.
Phillips Head Bolt: M6x3/8"
Qty: 4
Part # SB0004
Inset 1
Inset 3
Washer: M6
Qty: 4
Part # SB0005
Inset 2
0
15
Inset 2