Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
SAFETY INSTRUCTIONS
WARNING
1. Attach the coupling half (socket) to the
gas supply line in accordance with
NFPA54/ANSI Z223.1FUEL gas code.
2. Prior to inserting the plug, test the
connection for leaks following the leak
test instructions on page 11. After the
leak test is completed, rinse the
connection with clean water to remove
any corrosive residue.
3. Do not use open flame to test for leaks.
WARNING
When lighting, keep your face and hands as far
away from the grill as possible.
WARNING
Failure to properly place the burner over the
orifice could cause a fire to occur behind and
beneath the valve panel, thereby damaging the
grill and making it unsafe to operate.
WARNING
Do not leave the grill unattended while
cooking.
WARNING
Do not use the grill if the odor of gas is
present. Contact customer service at 1-800-
554-5799.
WARNING
Storage of an outdoor cooking gas appliance
indoor is permissible only if the cylinder is
disconnected and removed from the outdoor
cooking gas appliance.
WARNING
Cylinder must be stored outdoors out of the reach
of children and must not be stored in a building,
garage or any other enclosed area.
WARNING
Do not install this unit into combustible
enclosures. There should be a minimum
clearance of 24 inches from all sides to
combustible materials. Outdoor cooking
appliance shall not be used under
overhead combustible construction.
WARNING
A tank of approximately 12 inches in diameter by 18-
1/2 inches high is the maximum size LP gas tank to
use. You must use an OPD gas tank, which offers
an Overfill Prevention Device.
This safety feature prevents the tank from being
overfilled, which can cause malfunction of the LP gas
tank, regulator and/or grill.
CAUTION
When using the rotisserie burner, remove the
warming rack. High heat from the burner may
cause the warming rack to bend.
CAUTION
When using a match to light the grill make sure
to use the attached lighting rod.
CAUTION
Before cleaning, make sure the gas supply and
control knobs are in the “OFF” position and the
burners have cooled.
WARNING
Keep any electrical supply cord away from any
heated surface.
WARNING
Make sure the light switch is on “OFF” position
and power plug is disconnected from power
outlet prior to cleaning the glass cover.
.
WARNING
WARNING
To ensure continued protection against electric shock:
1. Connect to properly grounded outlets only.
2. Do not expose to rain.
3. Keep extension cord connections dry and off the
ground.
The light glass cover should not be in contact with
water or any other liquid when it’s warm. Sudden
change of temperature may cause cracks on glass
2