Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
FLAME CHARACTERISTICS:
Check for proper burner flame characteristics. Each burner is adjusted prior to shipment; however,
variations in the local gas supply may take subtle necessary adjustments.
Burner flames should be blue and stable. There should be no excessive noise, or flame lifting. If any of
these conditions exist please call your Dealer. If the flame is yellow, it indicates insufficient air. If the
flame is noisy and tends to lift away from the burner, it indicates too much air.
NOTE: small yellow tips are ok
TO LIGHT REAR BURNER OF THE GRILL:
THE WARMING RACK MUST BE REMOVED BEFORE LIGHTING THE REAR BURNER!
1. Read instructions before lighting.
2. Turn all knobs to “OFF” then open the L.P. tank valve. Always keep your face and body as far from
the grill as possible when lighting
3. Open lid during lighting.
4. Push down the safety valve switch button and hold on with right hand, allow the gas to reach the
burner.
5. Push and turn rear burner knob slowly to “HI” position with left hand 3 seconds later than push down
the button. The built-in igniter will click and spark simultaneously to light the pilot and burner in
sequence. Keep pushing the button for 10 seconds to allow the safety valve open. Turn the control
knob to OFF and release the button IMMEDIATELY if the burner does not light within 5 seconds,
wait 5 minutes for gas to dispel, then repeat the lighting procedure.
6. Follow match lighting instruction if burner can’t be lit after repeated 3-4 times.
TO LIGHT THE REAR BURNER BY MATCH:
1. Read instructions before lighting.
2. Open the lid during lighting.
3. Push and turn the rear burner knobs slowly to “HI” position, then release.
4. Push down the safety valve switch button with right hand and hold on, light by match with left hand.
Make sure the burner lights and stays lighted.
14