Interlink electronic L485SIB Gas Grill User Manual


 
14
www.ultrachefgrills.com
Problem Possible Causes Soluon
Burners burn with yellow
ame, accompanied by
the smell of gas.
Possible spider web or other debris, or
improper air shuer adjustment.
Thoroughly clean burner by removing.
See general maintenance instrucons.
Open air shuer slightly according to
combuson air adjustment instrucons.
(This must be done by a qualied gas
installer.)
Flames li away from
burner, accompanied
by the smell of gas, and
possibly dicules in
lighng.
Improper air shuer adjustment. Close air shuer slightly according to
combuson air adjustment instrucons.
(This must be done by a qualied gas
installer.)
Humming regulator. Normal occurrence on hot days. This is not a defect. It is caused by internal
vibraons in the regulator and does not
aect the performance or safety of the
gas grill. Humming regulators will not be
replaced.
Burners will not cross
light each other.
Plugged ports at back of burner. Clean burner ports. See burner
maintenance instrucons.
“Paint” appears to be
peeling inside lid or hood.
Grease build-up on inside surfaces. This is not a defect. The nish on the lid
and hood is porcelain, and will not peel.
The peeling is caused by hardened grease,
which dries into paint-like shards, that
ake o. Regular cleaning will prevent this.
See cleaning instrucons.
Infrared burner (if
equipped) ashes back
(during operaon the
burner abruptly makes
a loud “whoosh” sound,
followed by a connuous
blow-torch type sound
and grows dim.)
Ceramic les overloaded with grease drippings
and build-up. Ports are clogged.
Burner overheated due to inadequate
venlaon (too much grill surface covered by
griddle or pan.)
Cracked ceramic le.
Leaking gasket surrounding the ceramic le, or
a weld failure in the burner housing.
Turn burner o and allow to cool for at
least two minutes. Relight burner and
burn on high for at least ve minutes or
unl the ceramic les are evenly glowing
red.
Ensure that no more than 75% of the
grill surface is covered by objects or
accessories. Turn burner o and allow to
cool for at least two minutes, then relight.
Allow burner to cool and inspect very
closely for cracks. If any cracks are found,
contact your authorized Napoleon dealer
to order a replacement burner assembly.
Contact your authorized Napoleon dealer
for instrucons on ordering a replacement
burner assembly.