Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Installation (for qualified installers only) 23
© Travis Industries 4080214 100-01182_003
Approved Vent Configurations
Restrictor Position
• Intake and exhaust restrictors are built into the appliance to adjust the flow rate of intake air and
exhaust gases. Depending upon the vent configuration, you may be required to adjust the
restrictor positions. The charts for acceptable vent configurations detail the correct vent
restrictor positions.
Exhaust Restrictor Adjustment
If the diffuser is required to be in position # 2, you may wish to adjust the diffuser while the exhaust
restrictor is removed.
Loosen these four screws
on the exhaust restrictor.
Slide the restrictor to the correct
restrictor position (see the illustration
below). The rear screws indicate
restrictor position. In this example, the
restrictor is set in position # 3. Tighten
the screws to secure the restrictor.
NOTE: If using position 5 or 6 you will
need to remove the forward screws.
These screws are then re-inserted into
the back holes exposed while sliding
the restrictor.
(closed) #6
# 5
# 4
# 3
# 2
(open - stock position) # 1
Back of Firebox
Back Wall of Firebox
Firebox Roof