Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
35
POWER BURNER
Power burner air shutter adjustment is located on
dual necks of the power burner where they connect
with the gas manifold and orifi ces, as show in Fig.
35-1.
CAUTION: NEVER handle a hot burner.
To adjust the air shutters:
1. Remove the cooking grid and collimator.
2. Lift the back of the burner upward so that the
pin in the bottom back clears the hole in the burner
rest.
3. Move the burner back away from the front of the
grill while continuing to lift the back upward so that
it clears the rear fi re wall.
4. Turn the shutter to the desired opening size and
replace the burner to test the effect on the fl ame.
Burner fl ames should be blue with yellow tips.
Fig. 35-1
Inner
burner
Outer burner
Air shutters
BURNER AIR SHUTTER ADJUSTMENT (Continued)
ADJUSTING THE LOW FLAME SETTING
After changing gas orifices and adjusting the
regulator to burn a new gas, adjust the height of the
fl ame with a valve in LOW position so that is is
low without going out. Use the small adjusting
screw in the center of the valve stem. This screw is
accessible by removing the valve knob, which pulls
straight off the end of the valve stem.