Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
28
TANK ASSEMBLY
• Position tank into tank support as shown.
HOSE/REGULATOR
FIG.12
Before attaching hose/regulator to
tank, be sure cylinder valve and
appliance valves are OFF
.
The Q.C.C.1 cylinder valve has an internal
back check module which will not allow gas
to flow until a connection has been made.
The valve is turned off by rotating the
handwheel (Fig. 3, Use and Care)
Clockwise (left to right) until it stops. When
attaching regulator to tank, make sure that
the small probe (Fig. 13) in the nipple is
centered in the mating Q.C.C.1 cylinder
valve, turn the right hand threaded Q.C.C.1
nut onto the valve in a clockwise motion
until there is a positive stop. DO NOT USE
A WRENCH, HAND TIGHTEN ONLY.
IMPORTANT: Ensure hose assembly
does not contact the casting, or any other
parts which will get hot.
Q.C.C.I. NUT
TANK
HOSE/REGULATOR
WARNING: Before proceeding with the following steps, ensure you have read: • L.P. Gas Cylinder • Hose and Regulator
Sections of the USE AND CARE INSTRUCTIONS located at the front of this manual. The L.P. gas cylinder, if supplied with your grill, has been
shipped empty for safety reasons. The cylinder must be purged of air, and filled, prior to use. Follow all directions under "L.P. Gas Cylinder - Filling"
section of the Use and Care Instructions.
FIG.13
Assembled
View
Tank Not
Included