Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
www.desatech.com
108795-01N20
TO TURN OFF GAS
TO APPLIANCE
1. Turn off the wall switch.
2. Turn off all electric power to the appliance
if service is to be performed.
3. Fully open glass doors if installed.
4. Remove front hearth brick and control
access panel.
5. Turn gas control knob clockwise
to “OFF”. Do not force.
6. Replace front refractory brick access
panel.
7. Fully close glass doors if installed.
OPERATING FIREPLACE
Continued
Figure 40 - Pilot
Thermopile
Pilot
Burner
Ignitor
Figure 41 - On/Off Hand-Held Remote
Control Unit HRC100
Control
Button
Indicator
Light
INSPECTING BURNERS
Check pilot flame pattern and burner flame pat-
terns often.
PILOT ASSEMBLY
The pilot assembly is factory preset for the proper
flame height. Alterations may have occurred dur
-
ing shipping and handling. The pilot is located on
the back right hand side of the burner.
The height of the thermopile must be 3/8" to 1/2"
above the pilot flame. The flame from the pilot
burner must extend beyond the thermopile.
If your pilot assembly does not meet these re
-
quirements:
• Turn the adjustment screw marked pilot
clockwise to decrease or counterclockwise to
increase the flame to proper size (see Figure
39, page 19). Do not remove the adjustment
screw.
• see Troubleshooting
, page 19
OPTIONAL HAND-HELD
REMOTE OPERATION
Note: The receiver and hand-held remote
control kit must be purchased separately (see
Accessories, page 31). Follow installation in-
structions on page 10 of this manual.
1. After lighting, let pilot flame burn for
about one minute. Turn control knob to
ON position. Slide the selector switch to
the REMOTE position. Note: The burner
may light if hand-held remote was on when
selector switch was last turned off. You can
now turn the burner on and off with the
hand-held remote control unit.
IMPORTANT: Do not leave the selector
switch in the REMOTE or ON position
when the pilot is not lit. This will drain the
battery.
2. Press the control button on the hand-held
remote to turn the burner on. Press the
control button again to turn burner off (see
Figure 41).
3. To Lock press both buttons on remote
control until light stops flashing. Remote is
now locked. If the fire is on it will be turned
off automatically. In the locked state, the
light will not light up when any button is
pressed.
4. To Unlock press both buttons together on
remote control until light stops flashing.
The remote is now unlocked.