Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
www.desatech.com
111604-01E
21
HAND-HELD
REMOTE OPERATION
NOTICE: You must light the pilot
before using the hand-held re-
mote control unit. See
Lighting
Instructions
, pages 19 and 20.
When the appliance and the remote control are
switched off, the house icon with the room tem-
perature will be displayed. When the remote con-
trol is turned on, other icons will be visible and
the main burner of the appliance will turn on.
1. Turn control knob clockwise to
the ON position (see Figure 32, page 20).
2. Press the ON button on remote control (see
Figure 35). Wait 5 seconds to send a com-
mand to appliance.
Note:
An acoustic signal will be heard that con-
firms the reception of the command sent from
the remote control.
Setting Flame Height
Press the up or down key until the small tri-
angle is to the left of large flame icon at the top
of LCD display (see Figure 35). Press the left
or right key to set the desired flame height. Six
flame levels are available from 1 (minimum) to
6 (maximum).
OPERATING HEATER
Continued
Setting Room Temperature
Press the up or down key until the small tri-
angle is to the left of the thermometer icon (see
Figure 35). Press the left or right key to set the
desired room temperature.
Setting Timer (Sleep Function)
Press the up or down key until the small tri-
angle is to the left of the clock icon (see Figure
35). Press the left or right key to set the desired
sleep time. Maximum sleep time is 90 minutes,
in 15 minute increments. When desired time is
set, press the up or down key to start the timer.
When the desired time has elapsed, the appli-
ance will automatically switch off.
Child Safety Lock-Out
To lock the remote control keys, press the On/
Off key then immediately press the up key (see
Figure 35). The lock-out function is active when
the lock icon is lit. Repeat key sequence to un-
lock keys.
Low Battery Detection and Backup
A battery icon will be displayed on the LCD
display when batteries are low in the remote
control (see Figure 35).
When the receiver detects a low battery condi-
tion;
• Three acoustic "beeps" are generated from
the receiver
• Appliance is turned off and will go to the
maximum flame height
• Execution of commands is inhibited until
batteries are replaced
When batteries are low, it is not possible to turn
on the appliance with the remote control. Ap-
pliance can be turned on or off manually by
setting the backup switch of the receiver to
MAN position (see Figure 32, page 20). Remote
control and receiver will restart normal opera-
tion after batteries are replaced. See Installing
Batteries for Remote Receiver and Hand Held
Remote Control, page 18.
Timeout
If appliance is turned on and no command is
sent to the receiver for 24 hours, appliance will
automatically shut down. Commands sent af-
ter shutdown will be executed normally.
Left and
Right Keys
Increase and
Decrease
Set Points
On/Off
Button
Flame Height
Indicator
Thermometer
Icon
Clock Icon
Figure 35 - Remote Control
Small Triangle
Icon (Function
Indicator)
LCD Display
Room
Temperature
Display
Sleep Timer
Display
Lock-Out
Indicator
Low Battery
Indicator
Up and Down Keys
Moves Placement
from Top to Bottom
on LCD Display