Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
10
107050
VENTED TYPE DECORATIVE APPLIANCE
EVGL850N
®
4
3
2
1
INSTALLATION
Continued
GAS BURNER SUPPLY
HOOK-UP
1. Disconnect the burner form the burner
mounting flange by removing two
screws (see Figure 18).
2. Disconnect the pilot from the burner by
removing three screws holding the pi-
lot mounting bracket (see Figure 18).
3. Rotate the back of the burner forward
and lift out of the firebox.
Note:
Do
not damage pilot and gas line.
4. Remove the bottom refractory by lift-
ing and sliding out the front (see Fig-
ure 19).
Note:
Do not kink or damage
the flex line connector.
5. Remove the hearth pan with controls
intact by removing two screws at ei-
ther side of the pan.
6. Follow steps 1,2,3,4, and 5 in reverse
order to reinstall burner assembly.
LOG & EMBER PLACEMENT
1. Center the rear log on the support
bracket welded to the back of the
burner. Press the log down onto the
bracket (see Figure 20).
2. Align the groove cut into the bottom of
the front log over the metal strip on the
burner. Make sure the metal strip is
completely in the groove. Also make
sure the notches in the bottom of the
log align over the burner holes as shown
in Figure 21.
3. Place the straight, left log piece into the
notches on the left side of the front and
rear logs (see Figure 22).
4. Place the “T”-shaped, right log piece
into the notches on the right side of the
front and rear logs (see Figure 23).
NOTICE: Do not put lava rock on
burner or under burner. Placing
lava rock on burner could cause
performance problems.
Figure 18 - Removing Burner Assembly
Figure 19 - Removing Bottom Refractory
Burner Mounting
Screws (2)
Pilot Attaching
Screws (3)
1. Remove
Front of
Burner
2. Lift Refractory Over
Front Edge of Burner
Mounting Pan and
Remove from Firebox
Next remove the ember material from the
bag and flatten small amounts into pieces
about the size of a dime. Place the pieces
loosely onto the exposed section of the
burner ember tray, which is located on the
very front of the burner grate. This will
create the glowing appearance as the flame
touches the ember material. Do not block
burner ports by using too much ember ma-
terial in one area. Sprinkle a small amount of
vermiculite provided in the separate bag
over the embers to complete the effect. It is
not necessary to use all of the ember or
vermiculite materials provided.
To enhance the look of the hearth you may
optionally place the lava rock provided around
the front and sides of the burner. When fin-
ished replace the glass door, see Glass Door
Removal and Replacement on page 11.
Figure 20 - Installing Rear Log
Figure 21 - Installing Front Log
Figure 22 - Installing Left Log Piece
Figure 23 - Installing Right Log Piece
Rear Log
Burner Bracket
Front Log
Metal Alignment
Strip
Left Log
Piece
Notches
Right Log
Piece
Notches
Notches
Ember
Material