Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
ÖÖ
NOTE: Step 36 applies to you only if your grill is set up from the factory to use NATURAL GAS. If your grill is set up from
the factory to use LP GAS, skip back to Step 35.
Step
36
PLACE THE RUBBER PLUG ONTO THE GAS SUPPLY LINE. THEN
ATTACH THE SOCKET END OF THE QUICK DISCONNECT COUPLING
ONTO THE GAS SUPPLY LINE
. TIGHTEN WITH A WRENCH.
L
EAK TEST AT THE FUEL SOURCE CONNECTION WITH SOAP AND
WATER
. THE RUBBER PLUG IS USED TO PROTECT THE CONNEC-
TOR WHEN THE HOSE CONNECTOR IS NOT INSERTED
.
P
OSITION THE RUBBER CAP ONTO THE HOSE
C
ONNECTOR.
U
SE THE CAP TO COVER THE HOSE CONNECTOR WHEN NOT
ATTACHED TO THE FUEL SOURCE
.
T
O CONNECT AT THE FUEL SOURCE
:
PUSH BACK THE SLEEVE OF
THE QUICK DISCONNECT COUPLING AND INSERT THE HOSE CON-
NECTOR. RELEASE THE SLEEVE AND PUSH THE CONNECTOR INTO
THE COUPLER UNTIL THE SLEEVE SNAPS FORWARD
.
T
O DISCONNECT AT THE FUEL SOURCE: PUSH BACK THE SLEEVE
AND PULL OUT THE CONNECTOR
. THIS AUTOMATICALLY SHUTS
OFF THE GAS. IMMEDIATELY PLACE THE RUBBER PLUG INTO THE
QUICK DISCONNECT END
.T
URN OFF THE FUEL SOURCE SHUT
-OFF
VALVE IF APPLICABLE
.
WARNING: DURING ASSEMBLY OF GRILL AND WHEN
CONNECTING OR DISCONNECTING THE HOSE FROM THE FUEL
SUPPLY LINE
, INSURE THAT THE GAS SUPPLY HOSE IS FREE OF
KINKS AND
/OR DAMAGE AND IS AT LEAST 3” AWAY FROM HOT
SURFACES SUCH AS THE GRILL CASTING
.
CAUTION: MAKE SURE THE GAS CONTROL KNOBS
ARE IN THE
“OFF” POSITION BEFORE CONNECTING THE LOWER
END OF THE HOSE TO THE FUEL SOURCE
.
YOUR N
ATURAL GAS COMPANY MUST INSTALL AND CONNECT THE
GAS SUPPLY LINE TO THE GRILL
.
36-A
36-B
36-C
Quick Disconnect Coupling
Hose Connector
Rubber Cap
Quick Disconnect Coupling
Rubber Plug
ÖÖ
Attach a NATURAL GAS
line to the grill.
35