Coleman 7700 Series Gas Grill User Manual


  Open as PDF
of 48
 
Step
30
ÖÖ
Fasten one Door Handle to
the Sliding Drawer.
ÖÖ
NOTE: M4 x 5mm Screws
are factory installed into the
Handle.
ÖÖ
Install the Sliding Drawer
and Front Cover Panel onto
the Grill.
Hardware shown actual size
(EZ)
M4 X 5mm Screw
(2) Qty.
30-A. Fasten one Door Handle to the Sliding Drawer with two
Screws (EZ).
30-A
DOOR
HANDLE
SLIDING
DRAWER
EZ (x2)
30-B
30-B. Install the Sliding Drawer and Front Cover Panel.
SLIDING
DRAWER
FRONT COVER PANEL
ÖÖ
Assemble the Motor Mount
Bracket to the right outside of
the Firebox.
ÖÖ
Assemble the Left Support
Bracket to the left outside of
the Firebox.
Step
31
Hardware shown actual size
(TN)
M6 x 15mm Screw
(4) Qty.
(UO)
M6 Locking Hex Nut
(4) Qty.
31-A
TN (x2)
Motor Mount Bracket
31-A. Attach the Motor Mount Bracket to the metal side panel
using two Screws (TN), two Flat Washers (DY) and two
Hex Nuts (UO).
31-B. Slide the Motor onto the Motor Mount Bracket.
31-B
Motor
30
(DY)
M6 Flat Washer
(4) Qty.
DY (x2)
UO (x2)
 previous next