Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
31-C
TN (x2)
31-C. Attach the Left Support Bracket to the metal side panel
using two Screws (TN), two Flat Washers (DY) and two
Hex Nuts (UO).
Left Mount Bracket
NOTE
IF YOU ARE INSTALLING THE
SHORT SPIT ROD
FOR USE ON THE RIGHT BURNER, PROCEED WITH
STEP 32.
IF YOU ARE INSTALLING THE LONG SPIT ROD FOR
USE ON THE RIGHT BURNER AND LEFT BURNER
, SKIP
TO
STEP 33.
32-A
Handle
Set Collar
Fork
Slip Collar
Fork
Short Spit Rod
NOTE:
Machined
Groove
Toward
Handle
32-A. Loosely assemble the Rotisserie parts as shown in
Figure 32-A. Do not tighten the thumbscrews until
properly positioned in the grill.
ÖÖ
Install the Short Spit Rod into
the Firebox.
Step
32
32-B. Insert the Spit Rod into the Motor. Make sure
the machined groove is toward the handle.
ÖÖ
Place Slip Collar on Firebox Wall. Make sure
the pointed tip of the Spit Rod stays in the
Motor.
ÖÖ
Push Set Collar against the Slip Collar, provide
a small gap to allow the Spit Rod to freely turn.
ÖÖ
Tighten the thumbscrews on the Set Collar
and the Forks to hold in place.
32-B
Set Collar
Slip Collar
Center
Firebox
Wall
Small Gap here
31
UO (x2)
DY (x2)