Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
10
Grill Assembly — 8350 Series
Fig. 4
Igniter Battery Installation
1.
The AA battery, spring and igniter cap must be installed before
using (Fig. 4).
2.
Install the AA battery, negative end first.
3.
Slide the spring assembly over the battery.
4.
Screw the igniter cap onto the igniter (Fig. 5).
Fig. 5
1.
Insert the row of four heat tents with the triangle ridges
facing up (Fig. 1).
Interior Parts Installation
Fig. 1
Fig. 2
Fig. 3
Test the Igniter:
A spark should appear at electrode tips.
If the spark does not appear:
-Check the wire connections to the electrode module.
-Check the proper assembly of a fresh AA battery.
2.
Install the four cooking grates on the ledges provided on the grill
to create your cooking surface (Fig. 2).
3.
Place the warming shelf on the support brackets. The end
support rods slip inside the slots in the support brackets (Fig. 2).
4.
Remove the label from the drip tray. Open the door and install
the drip tray by sliding it into position as shown (Fig. 3). The drip
tray is located underneath the grill, inside the storage
compartment.
IMPORTANT: Remove all protective plastic film from stainless steel parts prior to assembly/use.
This film is installed at the factory to prevent damage that could occur during shipment and
handling.