Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
16
Burner Tube
C
Housing
Burner Portholes
Gas Tube
B
Gas Tube
Burner Tube
Ignitor Wire
Electrode
Hitch Pin
Hinge Pin
Thumbscrew
Shield
BACK OF GRILL
Rotisserie Burner
Hitch Pin
Hinge Pin
A
D
Cleaning The Rotisserie Burner
Follow these instructions to clean and/or replace parts of burner assembly or if you have trouble igniting the
grill.
1.
2. Disconnect ignitor wire from electrode (A).
3. Remove thumbscrew from shield (B), remove shield and clean any accumulation of grease with soap
and water.
4. Unfasten hinge pins and hitch pin. Note how hinge pins and hitch pins are attached.
5. Using a garden hose (preferably with nozzle), force water through burner tube. Make sure water
comes out of every burner porthole Open clogged portholes with a thin wire.
6. Examine rotisserie housing and burner closely (C). If any cracks or large holes (other than portholes)
are found replace rotisserie burner.
7. Wipe ceramic portion of electrode (A) with rubbing alcohol and cloth.
8. If grill is to be stored, coat burners lightly with cooking oil. Wrap in protective cover to keep insects out.
If not storing use following steps.
9. After burner has been cleaned, place rotisserie burner onto back of grill bottom and attach with hinge
pins and hitch pins.
10. Place gas tube inside burner tube, put shield over burner tube and secure with thumbscrew.
11. Attach flat end of ignitor wire (A) to electrode.
Turn gas off at control knobs and LP tank.
VERY IMPORTANT: Burner tubes must engage gas tube as shown (D).
.
Burner Tube