Aussie pmn Gas Grill User Manual


  Open as PDF
of 40
 
How to light your LP Gas Grill Side Burner (See
diagram below for illustrations)
1) Open Side Burner Lid
2) Important: Make sure Side Burner Control Knob is
turned “off” first. Make sure the LP gas cylinder valve is
open by turning the valve handle counter-clockwise until
it stops.
3) From the “Off” position, push in the Side Burner Control
Knob (right most knob of the control panel) and turn
counter-clockwise to the “high” position.
4) Push the igniter button several times so that it clicks each
time.
5) Check to make sure that the burner is lit.
6) If the side burner does not light, repeat Steps 3 and 4.
The burner should light within three or four attempts.
WARNING: If burner fails to light after following
Steps 3 & 4, turn Side Burner Knob to the “off”
position and close the valve on the LP gas cylinder.
Wait five minutes; then repeat all of the above
lighting procedures.
Note: If the burner still fails to light, refer to the
T
roubleshooting
page.
Lighting the Side Burner (Elite Series Only)
•Open Side Burner Lid before lighting to prevent an
explosion from gas build-up and to prevent burning the
paint.
2. Make sure Side Burner Control Knob
is turned “off” first. Make sure the LP
Gas Cylinder valve is open by turning
the valve counter-clockwise until it
stops.
1. Open Side
Burner Lid.
3. Push the Side Burner Control Knob and
turn counter-clockwise to the high position.
4. Push igniter
button to light.
32
 previous next