Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
STEP 8 - Mount Igniter/ Flavor Activator Mounting Stud to Grill Bowl
16
TOOLS
•Mount Igniter to Grill Bowl : With Tightening Nut removed, Insert Igniter threaded section down
through Igniter hole ( located in center and next to and in front of Burner) of grill Bowl from inside
until Igniter is resting on bottom of Bowl. NOTE: Do not remove or loosen the adjusting nuts on
Igniter as the correct height has been preset by the factory. (See Photo 1 below)
•Position open side of Igniter Box to face Burner and secure Igniter with Tightening Nut from
underside of grill Bowl. While keeping the Ignitor Box aligned with the edge of the Burner, tighten.
(See Photo 2 below)
•Insert 6M washer onto the threaded end of each Flavor Activator Mounting Studs. Insert Flavor
Activator Mounting Stud into center hole on each side of bowl and secure with 6M nut. (See Photo 3)
(ITEM 25)
IGNITER
(ITEM 52)
FLAVOR ACTIVATOR
MOUNTING STUD
2 pcs
(ITEM 27)
6mm WASHER
2 pcs
(ITEM 9)
NUT, 6M
2 pcs
Flavor
Activator™
Mounting
Stud
Tightening Nut - Comes on
threaded post of Igniter and
should be removed before
mounting on Grill.
Photo 1
Photo 2
Photo 3
3/16”
GAP
Collector Box
Electrode
Fig 1