Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
· Wash the porcelain or chrome coated Cooking Grids
with a mixture of hot water and baking soda.
· Empty the grease cup after each cooking session so
excessive grease does not accumulate.
Failure to remove grease may result in grease
dripping onto the cart and/or a grease fire in the
tray.
How to light your LP gas grill (See diagram below
for illustrations)
1) Open Hood
2) Important: Make sure control knobs are turned
“off” first. Open the LP gas cylinder valve by turning
the valve handle counter-clockwise until it stops.
3) From the “Off” position, push control knob in on the left
side and turn counter-clockwise to the high position.
4) Push the igniter button several times so that it clicks each
time.
5) Check to make sure that the burner is lit.
6) Light the remaining half of the burner by turning the control
knob counter-clockwise. Your grill has a crossover ignition
system that allows the burner to light each side successively.
7) If burners does not light, repeat Step 3. The burner
should light within three or four attempts. If burner still does
not light, try the right side.
WARNING: If both sides of the burner fail to light
after following Steps 3 & 4, turn all knobs to the “off”
position and close the valve on the LP gas cylinder.
Wait five minutes; then repeat all of the above lighting
procedures.
Note:If the burner still fails to light, refer to the
T
roubleshooting page. The burner can be lit manually, see
Manual Lighting of the Grill
.
8) After ignition, preheat the grill by turning the control knobs to
“High” for 3-5 minutes. The grill should be pre-heated before
every cooking session. The hood should be closed during
preheating.
WARNING: If a burner goes out during the cooking
cycle, turn all knobs to the off position and close the
valve on the LP cylinder. Open hood and wait five
minutes before attempting to relight the grill.
Preparation Before Cooking
Lighting the Grill Using Igniter
31
1. Open hood
2. Turn LP cylinder handle counter-clockwise to
open.
3. Push in left or right control knob and turn
counter-clockwise to the “High” position.
4. Push in Igniter to light.
· Open Hood before lighting the grill to prevent an
explosion from gas buildup.
· Always inspect the gas hose and regulator
assembly before each use. If the hose is cut,
damaged, or shows signs of excessive abrasion
or wear, do not use the LP gas grill. Contact the
manufacturer, as the hose and regulator assembly
must be replaced with an assembly specified by
the manufacturer prior to further use of the LP gas
grill.