Aussie Kanga Gas Grill User Manual


  Open as PDF
of 36
 
STEP 6-(CONTINUED) ASSEMBLE GRILL BODY TO CART- KANGA MODELS
•Turn Grill Body upside down and position between cart legs with the Hose and Regulator on the
Wheel Leg end. Do not lay Grill Body on, or step on, the Hose and Regulator.
•Align slotted holes on sides of Grill Body with
holes through edges of legs (Fig. E). Hold
Spacers between Leg and Body (Needle Nose
Pliers may help) and insert Body Bolts through
Leg, Spacers, and slotted holes in Grill Body.
Secure using Wing Nuts but only partially
tighten. Repeat assembly for remaining three
Cart Legs.
•Using a second person, turn full grill assembly
upright with wheels and casters on the ground.
The Grill Body should slide down to seat itself
in slotted holes. If not, loosen the Body Bolts
and push Body down at all corners.Tighten all
Body Bolts and Wing Nuts and then tighten all
other Bolts.
•Adjust the Lock Lever up or down on each
Caster to lock or unlock as desired. (NOTE:
Deluxe Models do not use casters.)
Continue assembly of Kanga at STEP 8.
SPACER
WINGNUTS
FIG. E
BOLT
CASTER LOCK
6mm X 110mm
BOLT
6mm X 110mm
BOLT
SPACER
WINGNUT
BODY
15
 previous next