Aussie 6805 Gas Grill User Manual


  Open as PDF
of 40
 
26
1. Open the Side Burner Lid.
2. IMPORTANT: Make sure Side Burner Control Knob is turned “Off” first.
3. Turn the LP Gas Cylinder valve open counterclockwise until it stops. (Fig. 8)
4. Push Side Burner Control Knob in and turn counterclockwise to the High position.
5. Hold lit Match near Burner.
6. If the Burner fails to light, repeat Steps 3-4.
If the burner fails to light after three or four attempts following Steps 3-6, turn the Side Burner Control Knob to the
“Off” position and close the LP Gas Cylinder valve to dissipate an accumulated gas. Wait five minutes; then repeat the
lighting procedure.
NOTE: If the Burners still fail to light, refer to Troubleshooting Section.
Manually Lighting the Side Burner
To reduce the risk of serious bodily injury or death from fire, explosion or burn hazard:
• Open Side Burner Lid before lighting the grill to prevent an explosion from gas build-up.
• When manually lighting Side Burner, use Matchlight Holder.
WARNING
!
Hold lit match
near Burner
Fig. 14
Lighting the Side Burner Sear Burner or Rotisserie Burner Model 6805
NOTE: Do not operate the Sear burner and Rotisserie burner at the same time. Do not use the Rotisserie burner when
main burners are in use. Remove the Warming Rack when using the Rotisserie Burner to prevent damage to the Warm-
ing Rack.
1. Open lid during lighting.
2. Make sure the Side Burner Knob, Sear knob or Rotisserie knob is in the “Off” position.
3. Turn on LP Gas Cylinder.
4. Push in and turn the Side, Sear or Rotisserie knob to the High position and hold in for 3-4 seconds. While holding
the knob in, push the starter button until the Burner is lit. Release the Starter Button but continue to hold the knob
in for another 10 seconds to allow the complete heating of the safety sensor.
5. If ignition does not occur in 5 seconds, turn the burner knob to the “Off” position and wait 5 minutes before
repeating the lighting procedure.
Side Burner Control Knob
 previous next