Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
23
5. Push the Igniter Button in until the Burner is lit. Listen for the spark ignition, and look to make sure the Burner is lit.
If no spark, see Troubleshooting Section on page 34.
6. From the “Off” position, light all other Burners from left to right, making sure each Burner is lit before lighting
the next. Your grill has a Crossover Ignition System that allows the Burners to light successively off one another.
Confirm each Burner is lit before lighting another Burner.
7. If the Burner fails to light, repeat Step 5. If it still does not light, try the next Burner from left to right.
If a Burner goes out during operation, turn all Control Knobs to the “Off” position and close the LP Gas Cylinder valve to
dissipate any accumulated gas. Open Hood and wait five minutes before attempting to relight the grill.
If any or all Burners fail to light after three to four attempts following Steps 4-7, turn all Control Knobs to the “Off” posi-
tion and close the LP Gas Cylinder valve to dissipate any accumulated gas. Wait five minutes; then repeat the lighting
procedures.
Lighting the Side Burner Sear Burner or Rotisserie Burner Model 6805
NOTE: Do not operate the Sear burner and Rotisserie burner at the same time. Do not use the Rotisserie burner when
main burners are in use. Remove the Warming Rack when using the Rotisserie Burner to prevent damage to the Warm-
ing Rack.
1. Open lid during lighting.
2. Make sure the Side Burner Knob, Sear knob or Rotisserie knob is in the “Off” position.
3. Turn on LP Gas Cylinder.
4. Push in and turn the Side, Sear or Rotisserie knob to the High position and hold in for 3-4 seconds. While holding
the knob in, push the starter button until the Burner is lit. Release the Starter Button but continue to hold the knob
in for another 10 seconds to allow the complete heating of the safety sensor.
5. If ignition does not occur in 5 seconds, turn the burner knob to the “Off” position and wait 5 minutes before
repeating the lighting procedure.
NOTE: If the Burners still fail to light, refer to the Troubleshooting Section on page 34. The Burner can also be lit
manually, see
Manual Lighting of the Grill on page 24.
3/16” gap
Gas Collector Box - If no spark,
pinch together or open Gas
Collector Box to adjust 3/16” gap
between electrode tip and V-notch.
Fig. 10