Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
19
5. Push the Igniter Button in until the Burner is lit. Listen for the spark ignition, and look to make sure the Burner is lit.
If no spark, see Troubleshooting Section on page 30.
6. From the “Off” position, light all other Burners from left to right, making sure each Burner is lit before lighting
the next. Your grill has a Crossover Ignition System that allows the Burners to light successively off one another.
Confirm each Burner is lit before lighting another Burner.
7. If the Burner fails to light, repeat Step 5. If it still does not light, try the next Burner from left to right.
If a Burner goes out during operation, turn all Control Knobs to the “Off” position and close the LP Gas Cylinder valve to
dissipate any accumulated gas. Open Hood and wait five minutes before attempting to relight the grill.
If any or all Burners fail to light after three to four attempts following Steps 4-7, turn all Control Knobs to the “Off” posi-
tion and close the LP Gas Cylinder valve to dissipate any accumulated gas. Wait five minutes; then repeat the lighting
procedures.
NOTE: If the Burners still fail to light, refer to the Troubleshooting Section on page 30. The Burner can also be lit
manually, see
Manual Lighting of the Grill on page 20.
3/16” gap
Gas Collector Box - If no spark,
pinch together or open Gas
Collector Box to adjust 3/16” gap
between electrode tip and V-notch.
Fig. 10