Weber Summit Gas Griill Gas Grill User Manual


  Open as PDF
of 32
 
32
CROSSOVER
®
IGNITION SYSTEM OPERATIONS
If the Crossover
®
ignition system fails to ignite the LEFT burner in a burner
set, light the LEFT burner with a match. If the LEFT burner lights with a
match, then check the Crossover
®
ignition system.
• Check that both ignition wires(1,2) are attached properly.
• Check that the Crossover
®
ignition button is activating.
• You should hear the igniter sparking.
If the Crossover
®
ignition system still fails to light, contact the Customer
Service Representative in your area using the contact information on our
web site. Log onto www.weber.com
®
.
(1 )
(2 )
MAINTENANCE
REPLACE IGNITER BATTERIES
Parts required: 1 AA alkaline battery per igniter.
Unscrew igniter button from bottom of control panel. Remove igniter button
and contact spring. Remove old battery and replace with a new AA alkaline
battery. Positive end(1) of battery faces up as shown in illustration. Replace
spring contact(2) and screw igniter button(3) back down.
ƽ ATTENTION: This product has been safety tested and is only certifi ed for use in a specifi c country. Refer to
country designation located on outer carton.
These parts may be gas carrying or gas burning components. Please contact Weber-Stephen Products Co., Customer Service Department for
genuine Weber-Stephen Products Co. replacement part(s) information.
ƽ WARNING: Do not attempt to make any repair to gas carrying or gas burning components without contacting
Weber-Stephen Products Co., Customer Service Department. Your actions, if you fail to follow this product
Warning, may cause a fi re or an explosion resulting in serious personal injury or death and damage to property.
 previous