Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Buy Weber Grill Parts. It couldn't be easier. Find your Weber parts here.
7
BUILT-IN CONSTRUCTION GENERAL INFORMATION
WARNING
A Weber-Stephen Products Co. factory
installed sleeve must be used for any
built-in installation.
CLEARANCE FROM COMBUSTIBLE SURFACES OR
STRUCTURES
Warning: Clearance from the outside walls of the
sides and back of the sleeve must be a minimum of
24 inches from a combustible surface. Measure from
the outside wall of the sleeve to the combustible
surface. Figure 2. Refer to “Install Gas Supply” on
page 2 before starting installation.
Figure 2
Figure 1
LOCATING YOUR SIDE BURNER
When determining a suitable location for your side burner
installation, give attention to concerns such as exposure
to wind, proximity to traffic paths, and keeping any gas
supply lines as short as possible. Never locate the Weber
Gas Side Burner in a garage, breezeway, shed, under an
unprotected overhang, or other enclosed area. Locate the
side burner and structure so there is enough room to
safely evacuate the area in case of a fire.
CLEARANCE FROM NON-COMB
USTIBLE SURFACES
OR STRUCTURES
Warning: Clearance from the outside walls of the
sides and back of the sleeve must be a minimum of 6
inches from a non-combustible surface. Measure from
the outside wall of the sleeve to the non-combustible
surface. Figure 1. Refer to “Install Gas Supply” on
page 2 before starting installation.
COMBUSTIBLE SURFACE
24 inches
24 inches
24 inches
NON- COMBUSTIBLE SURFACE
6 inches
6 inches
6 inches
WARNING: All countertop finished surfaces must be
constructed of a noncombustible material.
WARNING: All countertop finished surfaces must be
constructed of a noncombustible material.
Countertop
Countertop
Sleeve
Sleeve