Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Buy Weber Grill Parts. It couldn't be easier. Find your Weber parts here.
2
BUILT-IN STRUCTURE
CUTOUT DIMENSIONS
Side
475 675 Burner Tolerances
A31
5
⁄8”43
5
⁄8”10
3
⁄4”
B21
1
⁄8”21
1
⁄8”4
1
⁄2”
C 25” 25” 24”
WT 240 285 40
DIMENSIONS
+
3
⁄16”
- 0
+
3
⁄32”
- 0
+
3
⁄16”
-0
BUILT-IN CUTOUT DIMENSIONS
BUILT-IN STRUCTURE
SLEEVE DIMENSIONS
A
B
C
.625
TYP. TRIM
OVERHANG
DEPTH
HEIGHT
WIDTH
475 675 Tolerances
A31
1
⁄2”43
1
⁄2”
B21
1
⁄16”21
1
⁄16”
C24
15
⁄16”24
15
⁄16”
WT 240 285
DIMENSIONS
+
1
⁄4”
- 0
+
3
⁄16”
- 0
+
3
⁄16”
-0
BUILT-IN INSULATED SLEEVE
DIMENSIONS
Weight (expressed in pounds) represents the total weight
of the insulated sleeve and the cooking unit and does not
include the permanent structure housing the sleeve.
Specified insulated sleeve dimensions “A through C”
reflect the dimension to the mounting surface of the trim
excluding the .625 trim overhang.
If the supporting structure is going to have an
electrical outlet for a rotisserie, it should be on the
left side of the structure.
WARNING: Air holes must be provided in the
structure at the top and bottom to provide ventilation
in the event of a gas leak.
Air holes can be located in a low visibility area and should
be protected by screening material to prevent rodents and
insects from entering the structure. Air holes will also help
dry moisture.
Before installing the sleeve, lay a bead of silicon sealant
around the top perimeter and front sides of the structure
in the areas that the flanges of the sleeve will rest. This
will prevent moisture seepage. The sealant you use must
have a temperature rating above 120°F. If necessary,
caulk between the flange of the sleeve and finished
countertop surface.
WARNING: All countertop finished surfaces must be
constructed of a noncombustible material.
Countertop
Silicon sealant
Figure 3
Figure 4
Figure 5
Weight (expressed in pounds) represents the total weight
of the insulated sleeve and the cooking unit and does not
include the permanent structure housing the sleeve.
The sleeve must be supported from the bottom.
Recommended cutout dimensions “A through C” include a
nominal clearance dimension to facilitate installation. Any
additional clearance must be within tolerances shown or
fit-up of sleeve and built-in structure may be adversely
affected.
All dimensions are to finished surfaces.
All dimensions are to finished surfaces.