Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Buy Weber Grill Parts. It couldn't be easier. Find your Weber parts here.
D-6
You will need: LP cylinder, a soap and water solution
and a rag or brush to apply it.
1) Turn the LP cylinder so the opening of the valve is
either to the front, side or rear of the Weber Gas
Barbecue. Lift and hook the cylinder onto the fuel
gauge.
ƽ WARNING: Do not use a wrench to tighten the
connection. Using a wrench could damage the
regulator coupling and could cause a leak.
5) Mix soap and water.
6) Turn on the cylinder valve.
Liquid Propane Cylinder
The liquid propane cylinder manufacturer is
responsible for the materials, workmanship and
performance of the tank. If the tank has a defect
malfunctions, or you have a question regarding the
tank, call the tank manufacturer’s customer service
center. The phone number is on the warning decal,
which is permanently attached to the tank. If the tank
manufacturer has not resolved the issue to your
satisfaction, then contact the Customer Service
Representative in your region using the contact
information sheet provided with your manual.
We utilize various LP tank manufacturers. Some of the
tanks have differing top collar assembles. (The top
collar is the metal protective ring around the valve.)
One series of tanks mount with the valve facing front.
The other tanks mount with the valve facing away from
the fuel scale. These types of tanks are illustrated
below.
To Connect the hose to the cylinder:
3) Remove the plastic dust cover from the valve.
4) Screw the regulator coupling onto the tank valve,
clockwise, or to the right. Hand-tighten only.
2) Loosen the cylinder lock wing nut. Swing the
cylinder lock down. Tighten the wing nut.
Note: This is a new type of connection. It tightens
clockwise and will not allow gas to flow unless the
connection is tight. The connection requires tightening
by hand only.
7) Check for leaks by wetting the fitting with the soap
and water solution and watching for bubbles. If
bubbles form, or if a bubble grows, there is a leak.
If there is a leak, turn off the gas and tighten the fitting.
Turn the gas back on and recheck with the soap and
water solution.
If leak does not stop, Contact the Customer Service
Representative in your region using the contact
information sheet provided with your manual. Do not
use the barbecue.
8) When leak checking is complete, turn gas supply
OFF at the source and rinse connections with
water.
Connecting the Liquid Propane Cylinder
ƽ WARNING: Make sure that the LP cylinder valve
is closed. Close by turning valve clockwise.
ƽ DANGER
Do not use an open flame to check for gas
leaks. Be sure there are no sparks or open
flames in the area while you check for
leaks. Sparks or flames will result in a fire
or explosion which can cause serious
bodily injury or death, and damage to
property.