Weber Silver A Gas Grill User Manual


 
C-1
Installing Features
Install the right trim piece with tool holders
You will need: Right trim piece with tool holders
Push the Right trim piece into the frame as shown(1),
making sure that the tabs on the underside of the trim
piece are snapped into the slots in the frame.(2)
Install the left end trim piece
You will need: End trim piece, two 1/2 inch bolts, two
nylon washers and a wrench
Slide the end trim piece into the frame as shown. Add
washer to bolt and put through frame and hole in
frame trim piece. Tighten with wrench.
Install the work surface
You will need: work surface.
Place the work surface, so that the front and back
edges fit over the frame, in the area between the left
trim piece and the cooking box as shown.
Do not use the work surface as a cutting board.
C001.b
(1)
(1) Make sure that the tabs on the side table are to the
right, next to the cooking box.
(2)
(1)