Weber Silver A Gas Grill User Manual


  Open as PDF
of 32
 
B-8
(1)
(2)
(3)
(4)
Check:
1) Hose to manifold connection.
2) Regulator to cylinder connection.
ƽ WARNING: : If there is a leak at connection (1) ,
retighten the fitting with a wrench and recheck for
leaks with soap and water solution.
If a leak persists after retightening the fitting, turn
OFF the gas. DO NOT OPERATE THE BARBECUE.
Contact the Customer Service Representative in
your region using the contact information sheet
provided with your manual.
3) Valves to manifold connections.
4) The hose to regulator connection.
ƽ WARNING: If there is a leak at connections
(2), (3) or (4), turn OFF the gas. DO NOT OPERATE
THE BARBECUE. Contact the Customer Service
Representative in your region using the contact
information sheet provided with your manual.
When leak checks are complete, turn gas supply OFF
at the source and rinse connections with water.
(1) (2)
(1)
(1)
Install the slide out bottom tray
You will need: the slide out bottom tray(1), catch pan
holder(2), catch pan and one disposable drip pan.
Hook the ends of the catch pan holder into the hole in
the slide out bottom tray. The front of the catch pan
holder must be on the same side as the finger
grip(1) of the bottom tray.
Slide the bottom tray onto the mounting rails under the
cooking box with finger grip toward you(1).
ƽ WARNING: Do not line bottom tray with alumi-
num foil. It can cause grease fires by trapping the
grease and not allowing grease to flow into the
catch pan.
Put the disposable drip pan into the catch pan.
Slide the catch pan into the catch pan holder with its
finger grip towards you(1).
 previous next