Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Buy Weber Grill Parts. It couldn't be easier. Find your Weber parts here.
B-4
(1)
(2)
(1)
(2)
(1)
Install cylinder panel and frame connector
You will need: cylinder panel, frame connector, four 1
3/4 inch bolts, four nylon washers, two cylinder glides a
7/16 inch or adjustable wrench and pliers.
Insert the cylinder panel tabs(1) into the slots in the
frame brace(2).
Slide the cylinder panel up until notch at bottom of
panel fits over the cross brace. Add nylon washer to
the bolt, then insert bolt through the hole in the bottom
center of the cylinder panel, through the wheel frame
and into the end of the frame connector(1). Next, insert
the other bolt with a washer on it through the leg frame
and into the other end of the frame connector. Hold the
frame connector square and tighten the bolts with the
wrench. Add nylon washer to bolt and insert through
the hole in the wheel frame at the bottom right of the
cylinder panel, make sure that the bolt slips through
the hole in the cylinder panel. Add nylon cylinder glide
to bolt end and tighten bolt with the wrench while
holding the cylinder glide with the pliers. Repeat
procedure with the hole on the bottom left side of the
cylinder panel.
Install manifold bracket
You will need: manifold bracket.
Hook the bracket(2) onto the manifold in the center.
Place your hand underneath the bracket. Lift the
manifold, bracket and cooking box slightly, then hook
the tab of the bracket onto the frame brace(1).