Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Buy Weber Grill Parts. It couldn't be easier. Find your Weber parts here.
16
WWW.WEBER.COM
®
3
2
4
5
2
6
1
MANUALLY LIGHTING THE SIDE BURNER
ƽ DANGER
Failure to open the lid while igniting the side burner, or not
waiting 5 minutes to allow the gas to clear if the side burner
does not light, may result in an explosive fl are-up that can
cause serious bodily injury or death.
1) Open the side burner lid.
2) Check that the side burner valve is turned off (Push control knob in and turn
clockwise to ensure that it is in the “OFF” position) and all main burner control
valves are off (push in and turn clockwise).
3) Turn the gas supply valve on.
4) Put match in a match holder and strike match.
5) Hold match holder and lit match by either side of the side burner.
6) Push down and turn the side burner control valve to “HI”.
ƽ CAUTION: Side burner fl ame may be diffi cult to see on a
bright sunny day.
ƽ WARNING: If the side burner does not light:
a) Turn off the side burner control valve, main burners and gas supply
at source.
b) Wait 5 minutes to let the gas clear before you try again.
OPERATING INSTRUCTIONS
TROUBLESHOOTING
PROBLEM CHECK CURE
Burners burn with a yellow or orange fl ame, in
conjunction with the smell of gas.
Inspect Spider/Insect Screens for possible obstructions.
(Blockage of holes.)
Clean Spider/Insect Screens. (See Section “Annual
Maintenance”)
Symptoms:
Burners do not light. -or- Burners have a small
fl ickering fl ame in the “HI” position. -or-
Barbecue temperature only reaches 250˚ to 300˚
in the “HI” position.
The excess fl ow safety device, which is part of the
barbecue to cylinder connection, may have activated.
To reset the excess fl ow safety device turn all burner control
knobs and the cylinder valve off. Disconnect the regulator
from the cylinder. Turn burner control knobs to “HI”. Wait
at least 1 minute. Turn burner control knobs to “OFF”.
Reconnect the regulator to the cylinder. Turn cylinder valve
on slowly. Refer to “Lighting Instructions”.
Burner does not light, or fl ame is low in “HI”
position.
Is LP fuel low or empty? Refi ll LP cylinder.
Is fuel hose bent or kinked? Straighten fuel hose.
Does Burner 1 light with a match? If you can light Burner 1 with a match, then check the
Crossover
®
ignition system.
Experiencing fl are-ups:
ƽ CAUTION: Do not line the bottom tray
with aluminum foil.
Are you preheating barbecue in the prescribed manner? All burners on HI for 10 to 15 minutes for preheating.
Are the cooking grates and Flavorizer
®
bars heavily
coated with burned-on grease?
Clean thoroughly. (See Section “Cleaning”)
Is the bottom tray “dirty” and not allowing grease to fl ow
into catch pan?
Clean bottom tray.
Burner fl ame pattern is erratic. Flame is low when
burner is on “HI”. Flames do not run the whole
length of the burner tube.
Are burners clean? Clean burners. (See Section “Maintenance”.)
Inside of lid appears to be “peeling.” (Resembles
paint peeling.)
The lid is porcelain enamel or stainless steel, not paint. It
cannot “peel”. What you are seeing is baked on grease
that has turned to carbon and is fl aking off.
THIS IS NOT A DEFECT.
Clean thoroughly. (See Section “Cleaning”.)
Cabinet doors are not aligned.
Check the adjustment pin on the bottom of each door. Loosen adjustment nut/s. Slide door/s until aligned. Tighten
nut.
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web
site. Log onto www.weber.com
®
.
320