Weber 89838 Gas Grill User Manual


  Open as PDF
of 48
 
14
WWW.WEBER.COM
®
(1)
(2)
(3)
(1)
(2)
Side Burner Grate
Head Retention Clip
Side Burner Ring & Head
Igniter Electrode
Control Knob
Igniter Button
PROBLEM CHECK CURE
Side Burner burns with a yellow or
orange flame, in conjunction with the
smell of gas.
Inspect side burner orifice alignment
(Position of orifice to side burner tube.)
Loosen orifice and re-align orifice parallel to the side burner tube (3) .
(See Section “Side Burner Maintenance”)
Side Burner does not light. Is gas supply off?
The excess flow safety device, which is part
of the barbecue to cylinder connection, may
have activated.
Turn supply on.
To reset the excess flow safety device turn all burner control knobs and the cylinder
valve off. Disconnect the regulator from the cylinder. Turn burner control knobs to
START/HI. Wait at least 1 minute. Turn burner control knobs to “OFF”. Reconnect the
regulator to the cylinder. Turn cylinder valve on slowly. Refer to “Lighting Instructions”.
Flame is low in “HI” position. Is the fuel hose bent or kinked? Straighten hose.
Push button ignition does not work. Does burner light with a match? If match lights burner, check igniter (see Sideburner Maintenance).
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web
site. Log onto www.weber.com
®
.
SIDE BURNER MAINTENANCE
ƽ WARNING: All gas controls and supply valves should be in
the “OFF” position.
Make sure black wire is connected between the igniter and electrode.
Make sure white wire is connected between the igniter and grounding clip.
Spark should be a white/blue color, not yellow.
1) Igniter Wire
2) Ground wire
3) Burner
Side Burner Grate
Head Retention Clip
Side Burner Ring & Head
Igniter Electrode
Control Knob
Igniter Button
SIDE BURNER TROUBLESHOOTING
(4)
(5)
ƽ WARNING: The side burner orifice (4)
must be parallel to the side burner tube
opening (5).
 previous next