Weber 55009 Gas Grill User Manual


  Open as PDF
of 38
 
2
(1)
(1)
(1)
(2)
(1)
1) The smell of gas in conjunction with the burner flames
appearing yellow and lazy.
2) Barbecue does not reach temperature.
3) Barbecue heats unevenly.
4) One or more of the burners do not ignite.
ƽ DANGER
Failure to correct the above mentioned
symptoms may result in a fire, which can
cause serious bodily injury or death, and
cause damage to property.
Replacing Main Burners
1) Your Weber Gas Barbecue must be OFF and cool.
2) Turn gas OFF at source.
3) To remove control panel: take off the burner control
knobs. Remove the screws holding the control panel in
place. Lift off the control panel.
4) Unlatch the Spider Stopper™ Guards and remove
them.
5) Remove the manifold bracket and unscrew the two
wing nuts(1) that hold the manifold to the cooking box.
Pull the manifold and valve assembly out of the
burners and carefully set it down.
6) Slide the burner assembly out from under the guide
screw and washer(1) in the corners of the cooking box.
7) Lift and twist the burner assembly slightly, to separate
8) To reinstall the burners, reverse 3) through 7).
ƽ CAUTION: The burner openings(1) must be
positioned properly over the valve orifices(2).
Check proper assembly before fastening manifold in
place.
9) Reinstall the Spider Stopper Guards. Slightly rotate
the Spider Stopper Guards so that the seams are in
line with the Venturi fins(1). There should be no gaps
in the seams or in the fit around the burners(2) and
valves(3).
(3)
(2)
(1)
the crossover tube(1) from the burners. Remove the
burners from the cooking box.
ƽ CAUTION: If the Spider Stopper Guards do not fit
tightly, contact the Customer Service Representative
in your region using the contact information sheet
provided with your manual.
ƽ WARNING: After reinstalling the gas lines, they
should be leak checked with a soap and water
solution before using the barbecue. (See Step:
“Check for gas leaks.”)
 previous