Weber 41636 Gas Grill User Manual


 
6
ƽ DANGER
Do not use an open flame to check for
gas leaks. Be sure there are no sparks
or open flames in the area while you
check for leaks. Sparks or flames will
result in a fire or explosion which can
cause serious bodily injury or death, and
damage to property.
ƽ DANGER
Do not store a spare LP-gas cylinder under
or near this appliance. Never fill the cylinder beyond 80
percent full. If the instructions are not followed exactly, a
fire causing death or serious injury may occur.
1)
1).
1).
5).
4).
OFF
ARRETE
2).
START/
HI
3).
4).
1).
5).
4).
OFF
ARRETE
START/
HI
2).
3).
To Extinguish
Push in and turn burner
control knob clockwise to the
OFF position.
ƽ DANGER
Failure to open the lid while igniting the grill’s burner, or not waiting 5 minutes
to allow the gas to clear if the grill does not light, may result in an explosive
flame-up which can cause serious bodily injury or death.
Manual Lighting
1) Open the lid.
2) Make sure the burner control knob is
turned OFF.
ƽ WARNING: Do not lean over the open
grill. Keep your face and body at least
one foot away from the matchlight hole
when lighting the grill.
3) Push burner control knob down and turn to
START/HI.
4) Strike a match and put the flame
into the matchlight hole under
the igniter.
5) Check that the burner is lit by looking
down through the cooking grate. You
should see a flame.
ƽ WARNING: If the burner does not light,
turn the burner control knob to OFF
and wait 5 minutes to let the gas clear
before you try again or try to light with
a match.
Lighting
1) Open the lid.
2) Make sure the control knob
is turned OFF. (Push control
knob in and turn clockwise to
ensure that it is in the OFF
position.
ƽ WARNING: Do not lean over
the open grill. Keep your face
and body at least one foot
away from the matchlight hole
when lighting the grill.
3) Push burner control knob
down and turn to START/HI.
4) Push the red ignition button
several times, so it clicks
each time.
5) Check that the burner is lit
by looking down through the
cooking grate. You should see
a flame. ƽ WARNING: If the
burner does not light, turn
the burner control knob to
OFF and wait 5 minutes to
let the gas clear before you
try again or try to light with
a match.
Attach Propane Cylinder
Use propane cylinders with a capacity of 14.1
oz or less. Use propane cylinders that are
approximately 3" inches in diameter and 11"
inches in length. The propane cylinder must fit
through the cylinder support ring (1).
ƽ CAUTION: Use cylinders that are marked
“Propane fuel” only.
Note: Your Weber
®
gas grill is equipped with
a cylinder supply system designed for vapor
withdrawal.
Slide propane cylinder through support ring (1).
While holding carrying handle closest to propane
cylinder with one hand, push propane cylinder into
regulator and turn clockwise until tight.
ƽ WARNING: Do not use a wrench to tighten
the connection. Using a wrench could
damage the regulator coupling and could
cause a leak.
Check for gas leaks:
1) Regulator to propane cylinder connection.
ƽ WARNING: If there is a leak at connection
(1), remove propane cylinder. Do not
operate grill. Use a different propane
cylinder and recheck for leaks with soap
and water solution. If a leak persists after
retightening the propane cylinder, turn OFF
the gas. DO NOT OPERATE
THE GRILL.
Contact the Customer Service Representative
in your area using the contact information on
our web site. Log onto www.weber.com
®
.
2) Valve to-regulator connections.
ƽ WARNING: If there is a leak at connection
(2) turn OFF the gas. DO NOT OPERATE
THE GRILL. Contact the Customer Service
Representative in your area using the
contact information on our web site. Log
onto www.weber.com
®
.
When leak checks are complete, turn gas
supply OFF at the source and rinse connections
with water.