Weber 3400 LP Gas Grill User Manual


 
9
INSTALL WORK SURFACE
AND SIDE BURNER
FOR THE PLATINUM SERIES II 3200
You will need... left work surface, side burner assembly,
four 1/4-20 x 1/2 inch bolts, four nylon washers and a
7/16 inch or adjustable wrench.
Insert the left work surface tabs in the slots to the left of
the cooking box. Figure 12 (a). Slip washers on the bolts
and insert the bolts as shown. Tighten. Figure 12 (b).
Note: Remove protective covers from tabs of
side burners.
Insert the side burner assembly tabs in the slots to the right
of the cooking box. Figure 12 (c). Slip washers on the bolts
and insert the bolts as shown. Tighten. Figure 12 (d).
Side burner can only be installed on right side
of barbecue.
Platinum Series II 3200
Figure 12
Route the side burner hose so it will not interfere with the
scale indicator rod.
The side burner hose is connected in the following
manner:
Slide back the collar of the quick disconnect on the
manifold. Push the male fitting of the side burner hose
into the quick disconnect, and maintain pressure. Slide
the collar closed. Figure 13. Figure 14 shows the quick
disconnect engaged.
View from
left side
View from left
underside
View from
right side
View from right
underside
Manifold side view
Manifold side view
Figure 14
Figure 13
Male fitting
Quick disconnect
engaged
Side burner hose
Tabs
Tabs
Tabs
(d)
(b)
(c)
(a)
View from right
underside
To LP tank
To side burner
connection
Figure 15