Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Buy Weber Grill Parts. It couldn't be easier. Find your Weber parts here.
9
Step 14
Check for gas leaks
WARNING: You should check for gas leaks every
time you disconnect and reconnect a gas fitting.
Note - All factory made connections have been
thoroughly checked for gas leaks. The burners have
been flame tested. As a safety precaution you should
recheck all fittings for leaks before using your Weber
Gas Barbecue. Shipping and handling may have
loosened or damaged a gas fitting.
WARNING: Perform these leak checks even though
your barbecue was assembled.
You will need: a soap and water solution and a rag or
brush to apply it.
To perform leak checks: open tank valve by turning the
tank valve handwheel counterclockwise. Figure 20.
DANGER
Do not use an open flame to check
for gas leaks. Be sure there are no sparks
or open flames in the area while you
check for leaks. This will result in a fire or
explosion which can cause serious bodily
injury or death and damage to property.
c) Valves to manifold connections. Figure 21 (c).
d) The hose to regulator connection. Figure 21 (d).
WARNING: If there is a leak at c or d, turn OFF the
gas. DO NOT OPERATE THE BARBECUE. Contact
Weber-Stephen Customer Service.
When leak checks are complete, turn gas supply OFF at
the source and rinse connections with water.
Check for leaks by wetting the connections with the
soap and water solution and watching for bubbles. If
bubbles form or if a bubble grows there is a leak.
Note - Since some leak test solutions, including soap
and water, may be slightly corrosive, all connections
should be rinsed with water after checking for leaks.
WARNING: Do not ignite burners when leak checking.
Check:
a) Hose to manifold connection. Figure 21 (a).
b) Regulator to tank connection. Figure 21 (b).
WARNING: If there is a leak at a or b, retighten the
fitting with a wrench and recheck for leaks with soap
and water solution.
If a leak persists after retightening the fitting, turn
OFF the gas. DO NO
T OPERATE THE BARBECUE.
Contact Weber-Stephen Customer Service.
(a)
(c)
(d)
(b)
Step 15
Put the control panel back on
Set the control panel in place over both frame braces.
(Hold the Crossover Ignition button up while setting the
control panel in place.) Place your thumbs over the
control panel push-in buttons, and push them into the
frame brace until they snap into place. Figure 22 (a).
Push on the burner control knobs. Figure 22 (b).
Replace the right side worktable.
Figure 20
Figure 21
Figure 22
(a)
(b)