Weber 220 Gas Grill User Manual


 
LIGHTING INSTRUCTIONS
1).
2).
6).
2).
5).
OFF
3).
START/
HI
4).
4).
Manual Lighting
1) Open the lid.
2) Unfold the work surfaces (Q120, 200, 220).
3) Make sure the burner control knob is turned OFF.
Turn the cylinder on by turning the cylinder valve
anticlockwise (Q200, 220).
4) Strike a match and put the flame into the
matchlight hole under the igniter.
m WARNING: Do not lean over open barbecue.
Keep your face and body at least 30 cm
(12 inches) away from the matchlight hole
when lighting the barbecue.
5) Push burner control knob in and turn to
START/HI.
6) Check that the burner is lit by looking down
through the cooking grate. You should see a
flame.
m
WARNING: If the burner does not light, turn
the burner control knob to OFF and wait 5
minutes to let the gas clear before you try
again or before you try to light with a match.
To Extinguish:
Push in and turn burner control knob
clockwise to the OFF position.
m Caution: do not fold in tables until
grill is cold (Q120, 200, 220).
m WARNING: Do not lean over the open
barbecue. Keep your face and body at least
30 cm (12 in) away from the matchlight
hole when lighting the barbecue.
Turn the cylinder on by turning the cylinder valve
anticlockwise (Q200, 220).
4) Push burner control knob in and turn to
START/HI.
5) Push the red ignition button several times, so
that it clicks each time.
6) Check that the burner is lit by looking down
through the cooking grate. You should see a
flame.
m WARNING: If the burner does not light, turn
the burner control knob to OFF and wait
5 minutes to let the gas clear before you
try again or before you try to light with a
match.
1).
2).
6).
2).
5).
START/
HI
4).
OFF
3).
D
C
B
A
A. - LOW
B. - MED.
C. - START/
HIGH
D. - OFF
m DANGER
Failure to open the lid while igniting the barbecue’s burner, or not waiting 5
minutes to allow the gas to clear if the barbecue does not light, may result in an
explosive flare-up, which can cause serious bodily injury or even death.
Lighting
Summary lighting instructions are on the fold-out
work surface (Q120, 200, 220).
1) Open the lid.
2) Unfold the work surfaces (Q120, 200, 220).
3) Make sure the control knob is turned OFF.
(Push control knob in and turn clockwise to
ensure that it is in the OFF position.)
m Caution: do not fold in tables until
grill is cold (Q120, 200, 220).