Weber 1200 Gas Grill User Manual


 
22
Step 24
Complete accessory installation
You will need: Warm-Up Basket, warming rack, work table,
accessory rack, three tubing plugs, thermometer and a
hammer.
Insert one end of the Weber Warm-Up Basket into the hole
in the right end of the lid and the other end into the slot in
the left end of the lid. Figure 33 (a).
Set the warming rack into the slots at the rear of the
cooking box. Figure 33 (b).
Set the work table onto the left side rails. Figure 33 (c).
Set the accessory rack in place between the two frame
connectors. Figure 33 (d).
Insert the thermometer into its holder. Figure 33 (e).
Insert the tubing plugs into the ends of the frame. To fully
seat the plugs, you may have to tap them lightly with a
hammer. Figure 33 (f).
Figure 33
(a)
(b)
(c)
(d)
(e)
(f)
Position slide bar assembly on the outside of the caster
frame. Put a nylon washer on each 1 3/4 inch screw, insert
screws through frame and slide bar assembly and add
nylon washers and hex nuts. Tighten nuts using a
screwdriver and pliers. Figure 31.
Figure 31
View from front
of barbecue
Notch to the front
Slide bar
To lower table: Pull support rod up to disengage slide lock,
and lower table. To raise table, lift table up and engage slide
in locked position. Figure 32.
View from rear
of barbecue
Support rod
Locked position
Unlocked position
Figure 32
Slide
ƽCAUTION: To keep the barbecue stationary, the tabs
on the locking casters should be in the down position.