Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Page 7
Installation of electrical supply circuit should be done by a qualified electrician in accordance with local
codes and ordinances. In the absence of local codes or ordinances, the supply should be installed in
accordance with the National Electric Code ANSI/NFPA No. 70, current issue, or Canadian Electric Code
C22.1 Part 1.
The Thermador® Char Glo® barbecues use an electronic ignition system that requires a 120 VAC, 15A,
60 Hz power supply. A properly grounded duplex outlet must be provided adjacent to the lower left rear
corner of the unit. See Figure 5A (below).
A properly grounded duplex outlet made for outdoor applications should also be provided above the level
of the cooking surface on the left side of the unit. This outlet is required for connection of the rotisserie
motor. See Figure 3 (Page 5).
CAUTION CAUTION
SECTION 4: ELECTRICAL REQUIREMENTS
AND GROUNDING INSTRUCTIONS
WARNING
Electrical Grounding Instructions
This outdoor cooking gas appliance is
equipped with a three-prong (grounding)
plug for your protection against shock haz-
ard and should be plugged directly into a
properly grounded three-prong receptacle.
Do not cut or remove the grounding prong
from this plug.
BARBECUE
Three-Prong Plug and Receptacle
AVERTISSEMENT
Instruction pour la mise
a la terre electrique
Cet appareil est muni d’une fiche a trots
broches (mise a la terre) afin de vous proteger
des chocs et doit etre branche dire~ement
dans une prise de courant a trots broches
adequatement mise a la tem. II ne faut pas
couper ou enlever la broche de mise a la tem
de cette fiche.
Figure 5A