Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
10
Note - Since some leak test solutions, including soap and
water, may be slightly corrosive, all connections should be
rinsed with water after checking for leaks.
Make sure side burner is OFF.
To perform leak checks: open cylinder valve by turning the
cylinder valve hand-wheel counterclockwise.
ƽ WARNING: Do not ignite burners when leak checking.
Check for leaks by wetting the connections with the soap and
water solution and watching for bubbles. If bubbles form or if
a bubble grows, there is a leak.
Check:
1) Gas Line-to-”T” Connection
2) Regulator-to-Cylinder connection.
ƽ WARNING: If there is a leak at connection (1),
retighten the fi tting with a wrench and recheck for
leaks with soap and water solution.
If a leak persists after re-tightening the fi tting, turn
OFF the gas. DO NOT OPERATE THE GRILL. Contact
Customer Service 1-800-446-1071.
Check:
3) “T” Connection-to-Hose connections.
4) The hose-to-Regulator connection.
ƽ WARNING: If there is a leak at connections (2,3, or
4), turn OFF the gas. DO NOT OPERATE THE GRILL.
Contact Customer Service 1-800-446-1071.
When leak checks are complete, turn gas supply OFF at the
source and rinse connections with water.
GAS INSTRUCTIONS
CHECK FOR GAS LEAKS
After a period of nonuse, we recommend that you perform
the following maintenance procedures for your safety.
ƽ WARNING: Check the hose before each use of the
grill for nicks, cracking, abrasions or cuts. If the hose
is found to be damaged in any way, do not use the grill.
Replace using only Summit
®
authorized replacement
hose. Contact the Summit
®
Built-In Customer Service at
1-800-446-1071.
• Inspect the burners for correct fl ame pattern. Clean
if necessary, following the procedures outlined in the
“General Maintenance” section of this manual.
• Check all gas fi ttings for leaks.
ƽ DANGER
Do not use an open fl ame to check for gas
leaks. Be sure there are no sparks or open
fl ames in the area while you check for leaks.
Sparks or open fl ames will result in a fi re or
explosion, which can cause serious bodily
injury or death and damage to property.
ƽ WARNING: You should check for gas leaks every time
you disconnect and reconnect a gas fi tting.
Note - All factory-made connections have been thoroughly
checked for gas leaks. The burners have been fl ame-tested.
As a safety precaution however, you should recheck all
fi ttings for leaks before using your Weber Gas Barbecue.
Shipping and handling may loosen or damage a gas fi tting.
ƽ WARNING: Perform these leak checks even if your
barbecue was dealer or store assembled.
You will need: a soap and water solution, and a rag or brush
to apply it.
(4)
(3)
(2)
Side View
Side View
(1)