Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
10
WOLF GAS BBQ GRILL USE & CARE
MANUAL LIGHTING
Grill burners:
You may manually light the grill
burners with the match/lanyard holder. Place
t
he match in the clasp of the lanyard. Insert
into the
1
/2" (13) diameter hole above the grill
valve knob. Position the match tip near the
b
urner ports, push and turn the gas control
knob counterclockwise to HIGH, and light the
burner. Repeat to light the other burners. Refer
to the illustration below.
Open burners:
The open burners can be lit
directly from the top along the orifice holes
around the burner heads.
Rotisserie burner:
The rotisserie burner must
be manually lit at the pilot. Once the pilot is lit,
the burner will light within 30 seconds.
LIGHTING THE ROTISSERIE BURNER
The position of the infrared rotisserie burner
makes it more susceptible to being blown out;
t
he rotisserie should not be used during windy
conditions or in an unprotected area. For this
reason, the burner is equipped with a safety
v
alve that will prevent the burner from
operating unless the pilot is lit.
Open the hood and remove the rotisserie
burner cover.
Push in and turn the rotisserie gas control
knob to HIGH only.
After about 15 to 30 seconds, push the
ignition button for the rotisserie. This will
give the gas time to travel through the
tubing to the pilot at the left of the burner.
Once the pilot is lit, it will light the burner in
about 30 seconds. The flame is not visible
but it will give off high heat and a
red-orange glow after a few minutes.
Insert match/lanyard holder
for manual lighting
Manual lighting
If the rotisserie burner flame goes out
while the BBQ grill is in use, turn OFF the
gas control knobs immediately. Keep the
hood open and wait five minutes for the
gas to clear before relighting the burner.