Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Lift the grill pan clear of the support frame. The
support frame is held to the side rails by two clips on
each side.
For each side, support the side rail with one hand and
with the other hand lift the frame up and out of the
side clips.
For safety, push the side rails back into the grill
chamber.
The side rails can be removed to make cleaning the
grill chamber easer by unhooking them from the grill
chamber sides.
Slides can be wiped clean with soft cloth and mild
detergent.
use any abrasive substance.
When you have finished, hook the side rails back onto
the sides of the chamber. To refit the frame pull the
side rails forward and for each side in turn support
the side rail and press the frame down into the side
rails. Replace the grill pan.
The control panel and control knobs should only
be cleaned with a soft cloth wrung out in clean
hot soapy water -
Wipe with a clean
dampened cloth then polish with a dry cloth. The
oven doors should only be cleaned with a soft cloth
wrung out in clean hot soapy water.
On some models the oven door front panel can be
taken off so that the glass panels can be cleaned. If
the top edge of the oven door of your cooker has a
line of holes and there are screws in the side edges
then it can be taken apart for cleaning.
Move the cooker forward to gain access to the
sides (see the ‘Moving the cooker’ section of these
instructions).
Open the oven door slightly and remove the front
panel fixing screws from the door sides (two each
side).
some window doors only
Carefully lift off the outer door panel. The inside face
of the glass panels can now be cleaned - take care
not to disturb or wet the door insulation. Please note
that the door is triple glazed but the inner two panels
are fixed and should not be separated. After cleaning