PGS A-40 Gas Grill User Manual


 
14
Stainless Steel Column (A-S PED)
Step 3: Connect the Grill Head Bottom to
Aluminum Column (A-B PED) (Fig. 13A)
1. Attach the grill head bottom to the pedestal
column top with four ¼ - 20 x1 ½" Hex bolts,
washers under the bolt head, reinforcing bar and
Kep nuts. Note Reinforcing Bar used on the A-B
PED Aluminum Column.
OPTION: For Portable Base Only A-LC & A-NC: (Fig. 12)
1. Attach the wheels by slipping the axle through the base,
slide the wheels on and secure with the axle clips.
Finish by snapping the hubcaps on before standing unit
upright. For units with casters, place caster stem into
stem opening of the portable base, press and snap into
place. (Fig. 12)
Aluminum Column (A-B PED)
Fig 13A
Step 4: Attaching the Access Panel (Fig.
14)
Note: Do not attach the front access panel until the control
panel has been attached to the grill head bottom
and the gas supply line has been properly
connected and leak tested.
1. The front access panel attaches directly under the
control panel and hides the access opening. Lift the
access panel up behind the lip of the control panel,
then slip the bottom double edge of the access panel
(upward pressure may be needed) over the edge of the
access opening.
Step 3: Connect the Grill Head Bottom to Column
(Fig. 13)
1. Attach the grill head bottom to the pedestal column top
with four
¼ - 20 x1 ½" Hex bolts, washers under the bolt head and Kep
nuts. Peel the remaining protective coating off the pedestal
column.