Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
GRILL LIGHTING INSTRUCTIONS
WARNING: Always keep your face and body
as far away from the burner as possible
when lighting.
TO LIGHT THE SIDE BURNER
To light the side burner, remove any
cooking utensils from the burner grate.
Push and turn the control knob
counterclockwise to the “IGNITE/HI”
position. If the burner does not light, turn
the control knob to “OFF”. If the smell of
gas is detected and the igniter is not
functioning, immediately turn the control
knob “OFF”. Allow 5 minutes for any
accumulated gas to dissipate. If the side
burner igniter is not functioning, see the
following section for match lighting.
TO MATCH LIGHT THE SIDE BURNER
Hold a lit extended match or lighter near
the side burner ports, turn the control
knob counterclockwise to “IGNITE/HI”.
Move your hand immediately once the
burner is lit. Rotate the control knob to the
desired setting.
TO MATCH LIGHT THE GRILL
If the burner will not light after several
attempts then the burner can be match lit.
Lighting rod instruction:
Match light extension rod
Use this device to match light your burners
Simply place a lighted match between the
coils on the end of the extension rod and
hold next to the burner to ignite.
If you’ve just attempted to light the burner
with the igniter, allow 5 minutes for any
accumulated gas to dissipate. Keep your
face and hands as far away from the grill
as possible. Insert a lit match attached to
the lighting rod through the cooking grids to
the burner.(see next page) Press the
control knob and rotate left to the
IGNITE/HI setting, continue to press the
knob until the burner ignites. Burner should
light immediately. If the burner does not
light in 4 seconds turn the knob off, wait 5
minutes and try again.
15
Keep a spray bottle of soapy water
near the gas supply valve and check
the connections before each use.
Do not attempt to light the grill if odor
of gas is present. Call for service 1-
866-984-7455.
J19Y06P-1
TO LIGHT THE ROTIS BURNER:
Open the lid, push the knob for about 5
seconds without rotating.
This will allow time for the gas to flow into
the rear burner. Continue pushing for 5
seconds then turn the knob to the
IGNITE/HI position, then press the igniter
button to light the rotisserie burner. If the
burner does not light, turn the control knob
to “OFF”, wait 5 minutes and try again. If
the igniter does not function, follow the
instruction above for match lighting.